What does F07 mean on Hotpoint washing machine?
The error code F07 is the machine telling you that there’s a fault with the electronic circuit board, or that there’s a problem with the heating circuit.
Why is my Hotpoint washing machine not spinning?
Common solutions for: Hotpoint Washer won’t spin. The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer will not spin. To determine if the lid switch assembly is defective, use a multimeter to test the lid switch for continuity.
Why does my Hotpoint washing machine keep flashing F05?
F05 means there is a problem with the pump or there is a waste pipe issue. This problem will mean that your washing machine door may not release, leaving your washing trapped inside, or if it is opening, your washing will be sat in a pool of undrained water.
How do I fix F07 error?
The only thing you can do is try and reset the control by unplugging the washer or killing power to it at the breaker for a minute and restore power. If the F07 error persists after that then the motor control unit / MCU will need to be replaced.
What is fault F07?
F07 — Electronic circuit board fault / heating circuit fault. Issue: During a wash cycle the programme pauses part way through/ the machine is not heating and the pump runs continuously. Advice: We recommend you call our customer service centre to book an engineer on: 0344 822 4224. F08 — Heater fault.
What does it mean when your washer says F5?
Did you receive a F5 E2 lid lock alert? The F5 E2 alert indicates the washer can’t engage the lid lock because there may be an obstruction in the lid lock area. Please check the lid lock area and remove any objects in that area.
How do I fix error code F05 Indesit washing machine?
Indesit error F05 or F11
- Prepare a towel or a bucket.
- On the front side of the machine, open the hatch in front of the drain filter and unscrew the filter.
- Drain the excess water and collect it.
- Check if there’s a pin, coin or button in the drain and remove it.
- Clean and replace the drain filter.
What causes a washing machine to not spin and drain?
If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.
What is the problem if the washing machine won’t spin?
Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
What does F07 mean on a Whirlpool washing machine?
The Whirlpool Duet Washer F07 Error is Motor Control Unit (MCU) Error. The Central Control Unit (CCU) has detected a short in the motor control unit. The only thing you can do is try and reset the control by unplugging the washer or killing power to it at the breaker for a minute and restore power.
What does F0E7 mean on my washer?
Clothes detected Load detected while attempting
F0E7 – Clothes detected Load detected while attempting to run the Clean Washer Cycle.