What engine does an EZ Go golf cart have?
Engine Type For all models of the E-Z-Go, the engine is air cooled and produces 9 horsepower. The engine is a twin-cylinder unit, displacing 18 cubic inches.
How do you clean an electric golf cart motor?
All you need to clean these parts is a small brush – to break apart grease, dirt, mud, and other stains – a bottle of water, and a rag. You can use soap if you want but make sure that it is designed specifically for cleaning golf cart engines.
How do you convert a 36V golf cart to 48V?
It all depends on your battery bank used with this 36V to 48V conversion. can only be accomplished through installing a 48V motor capable of higher torque, or installing a 48V controller with a higher current limit (amperage). When DC power is discussed, amperage equals torque and voltage equals speed.
What kind of motor is in a golf cart?
Gas powered golf carts use regular unleaded gasoline. The average gas powered carts have 10 to 12 horsepower. These engines operate similar to that of a car which means that their maintenance will be similar to that of a car.
Are EZ GO golf carts fuel injected?
Technology designed to improve fuel economy and emissions. Textron Specialized Vehicles has introduced closed-loop electronic fuel injection (EFI) technology on all E-Z-GO RXV and TXT golf car models and for Cushman’s Hauler, Refresher and Shuttle vehicles.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won’t start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How do I change the motor in my EZGO electric golf cart?
You may wish to change the electric motor in your EZGO electric golf cart and replace it with a new one. Some carts motors can be difficult to change. The first step is to remove the wires connecting the battery pack to ensure that the cart has no power. It is advisable to use protective gloves. Do not use wristwatch, rings or jewelry.
How do you remove the motor from a golf cart?
Another simpler way to yank the motor out would be to remove the left side rear wheel of the cart out. You can then place the jack (if it is a hydraulic one) beneath the motor. This way, once you have removed all the cables connected to the motor and the bolts, it becomes very easy to remove the motor.
What to do if your golf cart has no power?
The first step is to remove the wires connecting the battery pack to ensure that the cart has no power. It is advisable to use protective gloves. Do not use wristwatch, rings or jewelry. If you have to access the motor from below the rear seat, you must lift the rear of the cart using a jack.
How do you install a speed sensor on an EZ Go motor?
Match the motor spline with the input shaft of the axle and align the orientation marks on the motor. Install the mounting hardware and use a torque wrench to tighten the nuts to 66 inch-pounds of torque. Connect the speed sensor to the motor’s end cover on EZ-GO PDS models.